Land reclamation program
Waste reclamation is the first clean project, because construction projects often leave a lot of garbage dirt, a variety of ground stones, walls will leave cement slurry, paint, glass glue, water pollution, rust and so on, which must be cleaned in the work of waste reclamation, so it is the most arduous, complex and demanding work, the quality of waste reclamation projects directly affects the future protection. Cleaning work quality and grade, so do a good job in opening up wasteland has very important requirements.
1. Clean up the decoration garbage left at the scene first.
2. Full vacuum from top to bottom;
3. Glass cleaning: first wipe the glass frame with a towel, then dip the diluted glass water solution with a water applicator, evenly coat the glass from top to bottom, with a spade to clean the stubborn stains, and then repeat the above process with a scraper from top to bottom, wipe the water marks left on the frame with a dry towel, and wipe the water marks on the glass with machine skin.
4. Toilet: adhere to the principle of top-down, first of all, recognize the material of the top of the toilet, whether it is PVC or aluminium plastic or paint, and then clean the walls of the toilet with different cleaning methods according to different materials; use cleaning balls or board brushes to clean the walls of the toilet, focusing on the crevices of ceramic tiles, and the glue, paint spots and cement stains left on the surface of ceramic tiles; use towels to clean the toilet. Sanitary wares in the living room are cleaned with stainless steel cleaning solution for various faucets and pipe fittings; the floor is cleaned by a floor washer for the last time, which is the corner of the ground; finally, after checking for no omissions, wipe the faucet and other pipe fittings with a dry towel.
5. Kitchen: Ibid. Note: Because there are many stainless steel pipes in the kitchen, they should be the focus of cleaning.
6. Bedroom and lobby: the walls are dusted with dusters, switchboxes are wiped, etc.
7. Door and frame: distinguish the material of the door, wipe it with a towel, the procedure is also from top to bottom, fold the towel into square, wipe it from the top of the door from left to right, no omission.
8. Ground cleaning: After all is done, the ground is cleaned, and the ground should also be divided into material, wood flooring, ceramic tile, or stone, when the distinction is made, choose a special detergent to dilute, and start cleaning. The glue stain on the ground can be removed by blade, and the stubborn glue removal agent can be used to deal with it. After the last process is completed, the foreman should check it thoroughly and confirm that there is no left-over glue and evacuate the scene.
9. Corner line: wipe with a towel, (remove all kinds of glue marks and paint spots with a knife blade, etc.).